Instructions

7
during one of the brief 10-seond flashes, it may not respond to the off
command. If this occurs, release and press the power button again until the red
light turns on. When the tag is on the light will flash briefly once every 10-
seconds, when it is off no flashes will be seen.
Pairing a Tag and Locator
If you purchase the Marco Polo locator with one included tag then no pairing
operation is needed and you may proceed directly to the “Tracking a Pet”
section below. If you purchased additional tags or if you have received a
replacement tag then you will need to transfer the unique ID code of the tag
into the locator before the tag can be used. To do this, first turn the tag off but
keep it nearby. Next, press and hold the Select button until Setup and Learn
appear on the display. Press the down arrow button so that Learn is flashing
and then press select to enter the learn mode. Now press the Pet button (1, 2 or
3) that you wish to assign to the new tag. “Searching” will now flash on the
locator.
Once the locator is in learn mode you have 20 seconds to turn the power
on to the tag you wish to assign to the selected Pet button on the locator. If
the tag and locator are successfully paired then the locator will beep two
short beeps and the Learn display will disappear. If you wait too long to
turn the tag on or if there is an error you will hear one long beep and the
locator display will say “No Signal”. If this happens, turn the tag power
off again and repeat the above process until the two beeps are heard.
Figure 5
Learn Mode Display
(Pet 2 Shown as an Example)
Flashing