Specifications

auxiliary leg can help to hold up the beam.

7) Insert as many “T” nuts in the beams as required. For example, you will need 3 “T” nuts for the

middle box beam’s inner channel and 3 “T” nuts for the palm beam’s inner channel in order to

install the keyboard tray. You will need 4 “T” nuts for each back cover brace (item 15, brace 1),

2 for the back beam bottom channel and 2 for the rear box beam outside channel. You will need

2 “T” nuts for each power strip, usually mounted on the rear box beam.

8) With the auxiliary leg holding up one end of the S5 frame, insert the four beams into the right leg

(item 1, Leg Right), using the same techniques outlined in step 1. Also, for the palm beam, use

the same technique with the spread plate and bus wire as outlined in step 4.

9) Install the four box beam braces (item 4) on each end of the box beams. Use four 5/16-18x3.5

bolts (043-06688-00) and four 5/16 lock washers (082-066889-00) for each box beam brace.

Use a ½” socket wrench. Do not tighten down fully until the frame is fully loaded and its width is