Specifications

5) Prior to inserting the palm beam (item 7) into the left leg, thread the bus wire through one of the

holes of the spread plate (part#726-06404-01, item 8), twist-locking the wire at the spread plate

end. Run the other end of the wire through its matching bolt hole on the left end of the palm

beam. The spread plate should mount inside the end of the palm beam, flat side up. As the

palm beam is inserted into the left leg (rounded side out) guide the bus wire into the matching

bolt hole of the leg. Insert a 3/8” 24x1.5 button head bolt through the leg hole and into the beam,

using the same techniques outlined in step 1. The auxiliary leg can help to hold up the beam.

6) Insert the back beam (item 13) into the left leg, using the same techniques outlined in step 1. The