Troubleshooting guide

MOBILE ANORAD GANTRY SYSTEM
- 42 -
4.1 Installing the DS1103 in the PC
The DS1103 PPC Controller Board contains a Plug and Play circuit that can be used with
ISA motherboards containing a Plug and Play BIOS. By default, the address switches on
the DS1103 board are set to 000(0x0000), which enables the Plug and Play feature.
Figure 20: The DS1103 Address Switches
To install the DS1103 board in the host PC
1) Turn off the host PC and disconnect it from the mains.
2) Open the enclosure of the PC.
3) Select an empty full length 16-bit slot with two free brackets next to it. Remove
the brackets that cover the openings on the rear side of the enclosure.
4) Insert the DS1103 and screw on the board’s triple bracket. The connector next to
the board is labeled P1, the second connector is labeled P2 and the third one P3.
Figure 21: The DS1103 board in host PC