Specifications

©1999 Euphonix, Inc. Page 7 Pilot Computer Manual
Rear Panel
Video Connector (15 Pin D sub) The video monitor (TFT) is connected here. This video cable
either be a long run (10 meters) from the Remote stand or a short run from an
extender box.
USB Ports (USB) Universal serial Bus ports. A USB modem can be connected here, but is
not currently configured for any purpose.
Network Port 1 (RJ45) A Local Area Network (LAN) can be connected at this port to give the
Pilot computer access to networked resources including Internet access if your facility
is so equipped.
Network Port 2 (RJ45) A second Local Area Network (LAN) can be connected at this port to
give the Pilot computer access to a separate set of networked resources. This
attachment of a second network will require further software configuration.
Trackball & Keyboard (PS2) Connect the Y-cable marked KYBD and MOUSE here.
IEEE 1394 Ports (1394) These ports are used for connection to IEEE1394 ports on the Studio
Hub and Audio Deck. 1394 carries control, status and feedback communication.
Remote (9 pin D sub) This port accepts the RS232/422 adapter and Remote cable, or
just the RS232 serial cable if an extender system is supplied. When an extender is
used the RS232-to-RS422 conversion takes place at the Remote.
SCSI (68 pin D-sub female) This port connects to external SCSI devices such as JAZ
drives, CD-R, or Kingston-mounted hard rives. The port is software enabled but not
typically used. Please check with Euphonix R-1 support to configure the port for
actual use.
Power Connector (IEC) The IEC power connector accepts standard IEC power cords. A
switching power supplied is used so voltages from 110volts to 240 volts, 50 or 60
cycle, can be input.
REMOTE
MOUSE
KBD
NTWK 2
SCSI
USB
TFT
NTWK 1
Primary
Network
Port
Video Monitor
Attach TFT
IEEE 1394
Connect one
to Hub
Trackball &
Keyboard
Y-connector
SCSI – port
may be used
with proper
set-up
Remote
USB Ports
NOT USED
Parallel Port
NOT USED
Network Port
N
OT USED