Specifications

Chapter 11: Dolby D/E Modules 143
Using the CAN Address switches on the FC972 or SY983 is an older method of setting the Frame ID. An explicit CAN Address must
be set only when employing a hardware CAN-BUS remote controller to configure frames. In System 5, the Frame ID is set with
the FC972’s IP Address for configuration using a web browser interface.
To set the CAN ID in range 0–15:
1 Set SW1-B to OFF.
2 Use the CAN Rotary Switch to set the CAN ID.
To set the CAN ID in range 16–31:
1 Set SW1-B to ON.
2 Use the CAN Rotary Switch to set the CAN ID.
Remote Configuration using a Web Browser
The DE911 is configured using a web browser interface, which requires fitting an FC972 Remote in the frame.
OVERVIEW Page
This page provides an overview of the frame’s modules. Click the wrench tool to open the configuration pages of that module.
Click the switch tool to open the PRESETS Page directly.
See “FC972 Remote” on page 35.
DE911 Web Configuration Overview page
wrench tool
switch tool