Instruction manual

Euphonix Modular I/O Configuration Guide Product Data Sheets

3/7

Installation

Set SW1 (A – D) if necessary (default = off)

Set SW2 (DEV0 – 2) for an appropriate CAN frame address (default = off).

Set SW2-4 (CAN-TERM) to terminate the CAN bus if required (default = off)

Location of label switches on the C8702 module.

The default IP address label is located on the “Coldfire” chip

of the controller module and on the front panel of the module.

While the MAC address is

printed on a label here

Can Buss Termination

Can Buss Termination must be done on either the SY982 Sync or FC972

Remote. Lack of termination or double termination may result in communication

errors in the system. Typically, Can Termination is done on the FC972.

Mode Switches

Mode switch A is set to “ON” for use with Euphonix consoles. Mode switches B,

C, & D are set to “OFF”

Setting the frame ID

Set DEV0, DEV1, & DEV2 to “ON.”

FC972 Remote