Instruction manual

System 5 Digital Audio Mixing System Operation Manual Dynamic Automation
191
Auto Join
Press the Auto Join key during the pass in which you wish to remember the punched
in parameters. After stopping the tape, rewinding, and resuming recording automation,
all parameters from the last pass are automatically punched in when the tape arrives at
the end of the last pass.
13.9.3 Snap Mode
Snap Mode overrides the A/Glide or M/Glide times for knobs and faders set to Auto or
Manual Glide by causing the knob or fader to abruptly shift from the level at the
punch-out point to the underlying automation level. Snap Mode is activated in the Au-
tomation Panel Page 1.
13.9.4 Update on Locate
Update on Locate controls how automation values are derived when the tape is relocated
between playbacks. When active, the automation values from the new location are loaded
before beginning playback. Update on Locate should usually be active when automation
values are stable and not being edited or recorded. It is located is in Automation Panel
Page 2.
When Update on Locate is inactive, the last value used during the previous playback
for that parameter is retained at the new location prior to playback. When playback be-
gins, the current location’s value (or the value derived from looking ahead or back) is
used. However, if the parameter is punched into record prior to beginning playback, the
previous setting is used. This is useful if you have experimented with setting a parameter
during the previous playback and wish to use that setting to begin another section.
13.9.5 All Match
All Match (bottom-right) punches out all parameters currently recording and glides/
snaps them back to their underlying automation value.
13.9.6 Auto Match
Auto Match automatically snaps to the underlying automation when timecode stops.