Instruction manual

System 5 Digital Audio Mixing System Operation Manual Dynamic Automation

188

To adjust the F/Start time by a few frames:

1. On the center section, press Recall then F/Start to transfer the F/Start time to

the locate time display.

2. Press the Trim +/- keys to alter the value in one frame increments.

3. Press Store Locate and then F/Start to transfer the new value to the F/Start field.

To modify the F/End time, perform the same steps but substitute the F/End for the

F/Start key.

NOTE: To set F/Start and F/End times, the center section Fill Start and Fill End keys

can be used interchangeably with the F/Start and F/End keys.

13.8.6 Fill Region + Fill Start + Fill End

Fill Region is used in combination with Fill Start and Fill End to set a value for a defined

region rather than throughout the mix. The punch-out point must be within the defined

region for the fill to apply.

1. Record a fader level from 00:01:00:00 to 00:02:00:00 so you can see how the

new level will override an existing one.

2. Enter 00:01:00:00 into the F/Start field and 00:02:00:00 into the F/End field.

See Section 13.8.5 - Setting Fill Start and End Times to see how to set the

times.

3. Now activate Fill Start, Fill End and Fill Region.

4. Record new fader movements in this section and punch out at the desired level.

The new level will be written from 1 to 2 minutes.

13.8.7 Fill Region + Fill End

1. Set the F/End time.

See Section 13.8.5 - Setting Fill Start and End Times to see how to set the

times.

2. Activate Fill End and Fill Region. Do not activate Fill Start.

3. Punch in, adjust the control, and punch out.

The value at the punch-out time is written to the time set for F/End.

Fill

Region

Fill

Region

Fill