Installation manual

Section 8: MIDI Remote Control

8 - 62 Euphonix CS3000/2000 MixView 3.0 Software Supplement

channel and program change), press the [*ST] key to link that preset to the

selected SnapShot. Before establishing the link, a confirmation menu is

displayed:

F3F1 F2 F4

The double-ended arrow indicates that you can change to another SnapShot at

this time if desired. To complete the link, press the [Enter] key. To confirm the

assignment, press the DSC [SnapShot] key and observe the MIDI preset

number in the SnapShot MIDI column:

MP37 linked to SS03

The ability to recall a console SnapShot from a second Euphonix console is

very useful in multiple console applications. In two operator systems for

example, you can link Snapshot recall between consoles or recall SnapShots

from any external MIDI controller. Since the intended purpose of this feature is

to facilitate multiple console SnapShot linking, all that is necessary to estab-

lish the link, is to connect MIDI cables between port 4 of both console’s MIDI

interface boxes. MIDI channels and console SnapShots will automatically be

connected in numeric order and ready for use.

From the top level MIDI menu, press [F4] (SS->SS) to display the SnapShot

Linking menu:

Remote Control of

Console

SnapShots

F3F1 F2 F4

Setup Snap System Grps File F-Link GPI MIDI

MIDI Menu

In Out Preset SS->SS

F3F1 F2 F4

Both TX (transmit) and RX (receive) parameters default to ON. [F1] and [F3]

toggle TX and RX respectively OFF/ON while [F2] and [F4] direct attention to

TX: ON 1 RX: ON 1