Installation manual

Section 7: Channel Function Enhancements

7 - 58 Euphonix CS3000/2000 MixView 3.0 Software Supplement

Now press the [

Bus] or [F3] keys to assign the MT bus to Out3.

F3F1 F2 F4

If M1 had been previously set as the Out3 source, MT replaces it. You may

also use the DSC Source Assign keys to assign additional sources to Out3.

When MT is selected to the Out3 bus, the M1 Out3 channel I/O source matrix

LED remains lit (for both M1 and MT assignments) along with the B LED (MT

for the CS2000).

1CH->OUT3 MT

Querying a

Channel’s Bus/Line

Routing

When viewing an individual channel’s meter settings and L4 is selected as the

meter source, you will see an arrow to the left of the L4 designation:

F3F1 F2 F4

The arrow designates whether the L4 source is currently coming from the line

feed in the patchbay or from the MT Bus. An

upward pointing arrow

desig-

nates Bus mode while a

downward pointing arrow

designates a Line/Tape

feed. L4 sourcing, however, cannot be changed from this menu. The arrow is

shown here just a convenient way to determine where your signal is currently

sourced from. This indication is not available via the global [Mtrs] key.

To change the L4 source routing for any channel, press the channel’s attention

key, [F4] (Route), [F2] (L4) and then [F3]/[F4] (BUS/LINE) to set the source.

F3F1 F2 F4

16CH->Aud:OFF Aud->L4

Out 1 Out 2 Out 3

1 2

3 4

1 2

3 4

1 2

3 4

U L

Out3, M1 designation

Indicates MT selected as Out3 source

M1 M2

L1 L2

L3 L4

16CH->L4 IN: BUS LINE

1CH-> L4 Dirs CMB