Installation manual

Section 7: Channel Function Enhancements

Euphonix CS3000/2000 MixView 3.0 Software Supplement 7 - 57

The following list details available selections:

LEFT METER:

Aud: M1, L1*, L3, CMB*, MT, LFL, UFL, OFF

Lvl: UF, UP, A, C, M1, OFF, LF, LP, B, D, M2

RIGHT METER:

Aud: M2, L2*, L4, MT*, CMB*, LFR, UFR, OFF

Lvl: LF, LP, B, D, M2, OFF, UF, UP, A, C, M1

An asterisk (*) indicates that choice is available only for F Rev channel hard-

ware.

Metering presets allow you to easily configure meter pairs. Pressing any

numeral on the DSC Numeric Keypad recalls these Meter selection presets.

Following is a list of the numeric presets available:

KEY LEFT METER: RIGHT METER:

E Rev F Rev E Rev F Rev

0 — Aud:OFF Aud:OFF Aud:OFF Aud:OFF

1 — Aud:M1 Aud:M1 Aud:M2 Aud:M2

2 — Aud:L3 Aud:L1 Aud:L4 Aud:L2

3 — Aud:MT Aud:L3 Aud:L4 Aud:L4

4 — Aud:LFL Aud:CMB Aud:LFR Aud:MT

5 — Aud:UFL Aud:MT Aud:UFR Aud:CMB

6 — Lvl:UF Aud:LFL Lvl:LF Aud:LFR

7 — Lvl:M1 Aud:UFL Lvl:M2 Aud:UFR

8 — - - - Lvl:UF - - - Lvl:LF

9 — - - - Lvl:M1 - - - Lvl:M2

For certain signal routing situations, the MT bus can be sent from Out3. This is

useful when the Dir 1 & Dir 2 connectors must be used to feed a 2/channel

Cube for example. Another example may be to obtain a stereo post fader

direct feed using Dir 1/2.

To set the Out3/MT routing, press the channel attention key at the top of the

channel, [F2] (OUTs) and then [F4] (OUT3):

Metering Presets

MT Bus to Out3

F3F1 F2 F4

16CH-> OUT1 OUT2 OUT316CH-> OUTs METER Route

16CH->OUT3 ?

789

456

123

SIDE NOTE:

Any combination of sources you

cannot monitor directly can be

monitored using the Combiner.