Installation manual

Section 7: Channel Function Enhancements

7 - 56 Euphonix CS3000/2000 MixView 3.0 Software Supplement

You can set the meter modes globally for all channel I/O meters or for indi-

vidual channels. To set the meter mode globally, press the DSC [Mtrs] key,

then [F2] (I/O):

F3F1 F2 F4

The two asterisks preceding the channel designator indicate that we are

affecting all I/O meters simultaneously. Pressing the [*ST] key from the Meter

Config menu switches you into individual meter config mode. There is another

way to set meter modes for individual channels. Press a channel’s attention

key located just under the I/O channel’s meter array, then press [F3] (METER):

F3F1 F2 F4

Starting with unconfigured meters, attention is initially directed to the right

channel meter as indicated by the arrow between Aud and OFF. Press [F2] to

direct attention to the left meter:

F3F1 F2 F4

Pressing [F2] again toggles the meter mode between Aud (Audio signal) and

Lvl (DCA level).

This new menu structure allows each meter’s source to be assigned using the

SpinKnob or [+]/[-] keys.

Meter Modes

1CH->Aud->OFF Aud:OFF

**CH->Aud:OFF Aud->OFF

Mode I/O Master

1CH-> OUTs METER Route

DIR

Bus

Meter Config Menu

Global Meter Menu

1CH->Aud:OFF Aud->OFF

Out 1 Out 2 Out 3

1 2

3 4

1 2

3 4

1 2

3 4

U L

SIDE NOTE:

Assigning meter modes

globally by using the DSC

Mtrs key, always

overrides and changes

any individual channel

meter assignments.