Installation manual

Section 7: Channel Function Enhancements
Euphonix CS3000/2000 MixView 3.0 Software Supplement 7 - 49
F3F1 F2 F4 F3F1 F2 F4
F3F1 F2 F4
16A-> SRC MODE ASGN
Aux Source Select Menu
16A-> SRC ? <-p . .
16A-> ON pre
F4 is used to set the aux send Fader Source Tracking. A lower case letter “p”
denotes pre fader routing and an upper case letter “P” denotes post fader
routing, while two dots “ . .” denotes fader tracking disabled. Press [F4] to
select Post Lower Fader Source Tracking:
F3F1 F2 F4
Repeat the previous steps for aux sends B, C and D. Once completed, the aux
sends’ sources will automatically “track” whatever sources have been se-
lected to the channel’s Lower fader.
Repeat the previous steps for aux sends C and D. Once completed, you can
verify routing by feeding a test tone to L4 and trying the aux sends. Be sure the
aux bus master controls are turned up and unmuted.
This concludes Exercise 1.
For reference, the possible aux send pre/Post routing configurations as seen in
the Aux Status menu are:
pre pre lower & upper fader
PostLF post lower fader
PostUP post upper fader
Aux source selections are independent from fader source selections by
default. However, if desired, you can set any aux send to “track” a fader’s
source selection changes using the Fader Source Tracking feature.
In this exercise, we will setup aux sends A thru D to source track channel 16’s
lower fader source selections.
Press channel 16’s aux A/B block attention key to display the Aux Status menu
and confirm that console attention is directed to aux send A. Press [F4] (down
arrows), then [F2] (SRC) to display the Aux Source Select menu:
Fader Source
Tracking
Exercise 2
16A-> SRC ? <-PLF
SIDE NOTE:
When setting Fader Source
Tracking, the aux source selection
changes immediately to match that
of the designated fader, overriding
any previous aux setting. Note that
the previous aux settings are
not restored if tracking is later
set off. After removing Fader
Source Tracking, the aux send
retains its current settings but no
longer follows any fader source
selection changes.