Installation manual

Section 6: Moving Faders
Euphonix CS3000/2000 MixView 3.0 Software Supplement 6 - 45
Auto Dynamic™. After an initial punch-in has written, automation data for a
fader, all subsequent punch-ins on that fader are done by touch-punch unless
the Touch preference is set OFF in the SmartDisplay menu. (See previous
section of this supplement)
It is also possible for the CS3000/2000 automation system to emulate these
other systems as well. You will first want to get a basic manual mix on your
console. Now, with Mix ON and the Punch menu showing in the SmartDisplay
(press the [Punch] key on the DSC), select the [Fdr] object key, press the
[Pass Rec] key above the Smart Display then press the [All upper] and [All
lower] keys on the DSC. This will punch in all faders and write a static level
into automation for all faders throughout the entire length of the mix. This is
comparable to the traditional “First Pass” common in other automation
systems. No tape needed to roll and the entire process takes about 10 sec-
onds. Now since all faders have valid automation data written to them, all
moving fader touch sensors are active.
Now that we have seen the changes made to the SmartDisplay, the next
section details the CS3000/2000’s general automation enhancements.