Installation manual

Section 5: Hyper-Surround
5 - 32 Euphonix CS3000/2000 MixView 3.0 Software Supplement
panner that is just the Sl-Sr (surrounds) sending to buses 4 and 5. All of these
formats and more are possible simultaneously with Hyper-Surround.
You will need 11 buses defined as pan buses in your Cube to complete all
three exercises. To quickly determine the number of pan buses available, press
the DSC [Pan Assign] and then [Bus Master] keys to view the Pan Bus
Master screen. The number of red bus master pots displayed on the screen
indicates the number of Pan buses available. Again, see the Cube section of
the main manual for details on how to define Cube buses. If you have fewer
than 11 Cube buses, complete as many exercises as possible until you run out.
Exercise 1
Setting Up a 5.1 Panner
Press the DSC [Pan Assign], [F4] (down arrows) and then [F2] (Setup) to view
the Pan Assign menu (only the DSC Pan Assign key should be lit).
DynEQ
Pg 1 Pg 2 Pg 3 Pg 4
Aux Pan
Assign
Bus
Master
Chan
List
DynEQ Aux Pan
Assign
Bus
Master
Chan
Pg 1 Pg 2 Pg 3 Pg 4 List
All panner setup operations use the “MCP” (Master Control Panel) section of
the DSC.
F3F1 F2 F4 F3F1 F2 F4
F3F1 F2 F4
Pan Setup Menu
Preset Setup Active
P1-> – – – – – – : – – – B – –
3P1-> OFF