Installation manual

Section 4: The Audio Cube

4 - 26 Euphonix CS3000/2000 MixView 3.0 Software Supplement

Operational configurations are often done on a session by session basis. It is

easy to reenter these menus and re-configure aspects of the system the

needs demand.

The first step in Operational Configuration is to define the bus types as to

their function. Buses are defined as “Aux” for use as Cube aux sends and

“Pan” for use in building Hyper Surround™ Panners.

Press the DSC [Bus Master] key to view the top level Cube Bus Master

menu.

Operational

Configuration

The lower right quadrant represents the 48 possible Cube output buses. As

mentioned earlier, each QBC card adds 4 buses. Therefore each row in the

screen above represents 3 cards or 12 output buses.

Notice the Link indicator for each of the 48 buses. The two white lines below

it is the Insert indicator. While in the Bus Configure menu use the SpinKnob to

select the desires bus (see the black box above the bus move). Now press [F3]

to toggle the bus link on and off. Press [F4] to toggle the Insert on and off. The

result can be seen in the menu and on the screen.

F3F1 F2 F4

Define Bus Types

Bus Link and Insert

Below is a portion of the Cube Bus Configuration screen with no Cube buses

configured yet. With no buses configured, no Bus Master controls appear on

the screen.

AUX [none] 01:Lnk

F3F1 F2 F4

Bus1-> OFF

AUX [none] 01:Lnk – –

I/O Bus Assign