User guide
Table Of Contents
- List of Figures
- Chapter 1: Introduction to the Artist Media Controller
- Chapter 2: Setup and Installation
- Chapter 3: Common Tasks
- Chapter 4: Surface Controls
- Chapter 5: EuControl
- Appendix A: Setting the IP Address
AUDIO | VIDEO MEDIA CONTROLLER
USER GUIDE
SURFACE CONTROLS
30
STOP
Press STOP to stop all other functions.
PLAY
Press PLAY to play the project from the current location.
REC
Press REC begin recording at the current location. All tracks armed for recording
are punched into record.
4.3.6 SEL
Pressing a fader’s SEL key selects that track in the application and attentions
(see Channel Mode on page 34) it on the MC Mix.
NOTE: Some applications allow selecting multiple tracks if the Shift key on the work-
station is held down while selecting tracks. In this case, the attentioned track
is the last one selected.
4.3.7 ASSIGN
Press the ASSIGN key to display the Assign tab in the EuControl Settings dialog
(see Assign on page 49).
4.3.8 REC
Press the REC key to enable recording on a track. The REC key lights red to indicate
that track is enabled (armed) for recording. Press the REC key to cancel a track
enabled for recording.
NOTE: Some applications blink the REC LED when armed but not recording and light
solid when recording.
4.3.9 AUTO
To change an application track’s automation mode, press the AUTO key until the
desired automation mode appears in the channel display.