User guide
Table Of Contents
- List of Figures
- Chapter 1: Introduction to the Artist Media Controller
- Chapter 2: Setup and Installation
- Chapter 3: Common Tasks
- Chapter 4: Surface Controls
- Chapter 5: EuControl
- Appendix A: Setting the IP Address
AUDIO | VIDEO MEDIA CONTROLLER
USER GUIDE
SURFACE CONTROLS
28
4.3.2 Fader
The fader controls the track assigned to this strip. It is motorized so it reflects
changes made in the application, such as automation. It is also touch sensitive,
which some applications use when automating.
Figure 4-3 Fader strip
When the Select by Touch General preference is selected (page 45), touching a
fader selects that track in the application and attentions it on that strip. This is
the same as pressing the fader Sel key.
Holding down the Shift key and touching a fader sets it to unity gain.
4.3.3 ON
The track is on (unmuted) when the strip’s On key is lit and off (muted) when the
strip’s On key is not lit.
4.3.4 SOLO
The SOLO key lights red when that strip’s track is soloed and is unlit otherwise.
A
U
T
O
REC
N
ASSIGN
SE
L
Y
12
60
40
6
0
5
10
20
30
8
SOLO
ON