Instruction manual

Euphonix FT730 FiberTran Fiberoptic Extender Operation Manual

Figure 3 Rear Panel Sync Connectors

AES/SYNC IN (female XLR or BNC), WORD IN (BNC): Connect this port to

a digital sync reference (local unit only). Selection for XLR or BNC input is done

using two internal jumpers shown in Figure 4. The unit is shipped with the jump-

ers set for the XLR input.

AES/SYNC OUT (male XLR or BNC), WORD OUT (BNC): Connect one of

these ports to the digital sync reference input of any device receiving MADI at

the remote unit. Only one output connection (XLR or BNC) should be used at a

time.

RETIMED AES/SYNC OUT (male XLR), RETIMED WORD OUT (BNC):

Connect one of these ports to the digital sync reference input of any device send-

ing MADI from the remote unit back to the local unit. See Synchronization for

Distances Over 800 ft (250 m) on page 13 for more information about these out-

puts.

Figure 4 Internal Sync Input Jumper

1 2 3

BNC

XLR