User's Manual

3. If an AP is detected, the utility program will show the AP information .

4. Double click the found AP from the list table.

5. Input the IP Address, subnet mask and default gateway correctly, click

the “OK” button, you MUST assign the AP IP address with the value

that is located within the same subnet of the configured PC.

V. Hardware Specification

Radio: Complies with IEEE 802.11

Frequency Band: 2400 ~ 2483.5MHz ( for US, Canada, and ETSI)

2400 ~ 2497MHz (for Japan)

Modulation TYPE: CCK,BPSK,QPSK

Operating Channels: IEEE 802.11 compliant

11 channels (US, Canada)

13 channels (ETSI)

14 channels (Japan)

Radio Technology: Direct Sequence Spread Spectrum

Data Rate: 1 / 2 / 5.5 / 11 Mbps

Output Power: > +15dBm

Receive sensitivity: Min. -78dBm for 11Mbps; Min. -82dBm for 5.5/2/1

Mbps ;(@BER 10E-5)

Ethernet :

Wired Interface : Ethernet IEEE 802.3 10 BaseT

Current Consumption : 5V, 750 m A Max.