User's Manual

Federal Communications Commission Statement

This device complies with FCC Rules Part 15. Operation is subject to the following

two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may

cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy. If this equipment is not installed and used in accordance with the

manufacturer's instructions, it may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by during

the equipment off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

! Reorient or relocate the receiving antenna.

! Increase the separation between the equipment and receiver.

! Connect the equipment to an outlet on a circuit different from that

to which the receiver is connected.

! Consult the dealer or an experienced radio/TV technician for help.

The use of shielded cables for connection of the monitor to the graphics card is

required to assure compliance with FCC regulations. Changes or modifications to

this unit not expressly approved by the party responsible for compliance could void

the user's authority to operate this equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator and

your body.

Manufacturer's Disclaimer Statement

The information in this document is subject to change without notice and does not

represent a commitment on the part of the vendor. No warranty or representation, either

expressed or implied, is made with respect to the quality, accuracy or fitness for any

particular purpose of this document. The manufacturer reserves the right to make

changes to the content of this document and/or the products associated with it at any time

without obligation to notify any person or organization of such changes. In no event will