Product Card

EULUM DESIGN LLC 6131 • Kellers Church Road • Pipersville • PA • 18947 • USA
EULUM DESIGN LTD Unit 4 • Zone D •Chelmsford Road Ind. Est • Dunmow • CM6 1XG • UK
www.eulum.com
[e-mail]
UK: [phone]
USA: [phone]
RFM-CSB-3
3. End Product Labelling
The final end product must be labeled in a visible area with the following:
RFM-CSB-3: “Contains FCC ID: 2AJML- EUCSBM”
Any similar wording that expresses the same meaning may be used.
The FCC Statement below should also be included on the label. When not possible, the FCC
Statement should be included in the User Manual of the host device.
“This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.”
4. Information regarding the end user manual
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module in the user’s manual of the end product which integrates
this module. The end user manual shall include all required regulatory information/warning as
show in this manual.
CE Regulatory
This device is tested and compliant against the following standards. OEM integrators should
consult with qualified test house to verify all regulatory requirements have been met for their
complete device.
● EN 50663:2017
● EN62368-1:2014/A11:2017
● ETSI EN 201-489-1 V2.2.3
● ESTI EN 301 489-17 V3.2.2
● ESTI EN 300 328 V2.2.2