User Manual

20 21
Anti-drop sensors will prevent RoboVac from tumbling down stairs and steep drops
in most cases. Sensors are less effective if dirty or used on carpeted/reflective/very
dark-colored floors. It is recommended to place physical barriers to block off areas
where RoboVac may fall.
Place physical barriers in front of fireplaces and areas that may cause damage to
RoboVac if entered.
Preparation
1
Remove the foam blocks beside the bumper before use.
2
Install the side brushes before use.
3
Before mopping, attach the waterproof pad to the Charging Base to keep the floor
dry. Make sure it is firmly installed. If mopping is not needed, you can skip this
step.
4
Turn on the main power switch on the bottom of RoboVac.
OFF
ON
5
Place the Charging Base on a level surface and against a wall.
6
Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of
the front of the Charging Base. If you cannot remove the objects, check whether
RoboVac can return to the Charging Base normally; if not, contact eufy customer
service for help.