SDS

湖南炬神電子有限公司
HU NAN GIANTSUN POWER ELECTRONICS CO., LTD
13
4.3 Battery Cell Performance Criteria
電芯性能檢查及測試
4.3.1 Electrical characteristics
電氣性能
表四
No.
序號
Items
項目
Test Method and Condition
測試方法與條件
Criteria
標準
1
Standard
Charge
標準充電
Charging the cell initially with constant
current at 0.2C and then with constant
voltage at 4.2V till charge current
declines to 50mA.
先用 0.2C 恒流充電至 4.2V ，再恒壓 4.2V 充
電直至充電電流 50mA。
N.A.
2
Initial
Capacity
初始容量
The capacity means the discharge capacity
of the cell, which is measured with
discharge current of 0.2C with2.5V cut-off
voltage after the standard charge.
該容量是指標準充電後，0.2C 放電至 2.5V 截止
電壓所放出的容量。
≧3350mAh
3
Cycle Life
循环寿命
Test condition：
Charge: 0.3C to 4.2V
Discharge: 0.2C to 2.5V
80% or more of 1
st
cycle capacity at 0.2C
discharge of Operation
測試條件：
充電：0.2C 充電到 4.2V
放電：0.2C 放電到 2.5V
當放電容量降至初始容量的 75%時，所完成的循
环次數定義為該電芯的循环壽命
300cycles:
 75%
4
Self-discharge
自放電
After the standard charging, storied the
cells under the condition as No.4.3.4 for
30days, then measured the capacity with
0.2C till 3.0V
標準充電後， 在 No.4.3.4 條件下貯存 30 天，
再以 0.2C 放電至 2.5V 所放出的容量。
Residual
capacity > 90%
剩餘容量 > 90%
5
Initial
Impedance
初始內阻
Internal resistance measured at AC 1KHz
after 50% charge
半充狀態下，測量其 AC 1KHz 下的交流阻抗
70mΩ
(Cell only)
(單電芯)
6
Cell Voltage
電芯電壓
As Shipping Status
運輸狀態
3.5V～3.7V