SDS

湖南炬神電子有限公司
HU NAN GIANTSUN POWER ELECTRONICS CO., LTD
7
2.3 Safety Performance
安全性能
表二
No.
序號
Items
項目
Test Method and Condition
測試方法與條件
Criteria
標準
1
Over-Charge
Protection
過充保護
At 20±5℃ conditions, after
fast-charging, use an external 10V
power to load the battery and last
for 8 hours, then check the
appearance of battery.
在環境溫度(20±5)℃下, 電池快
速充電結束後,用電壓為 10V 外接電源
持續給電池載入 8 小時，再檢查電池外
觀。
The appearance is normal, no
explosion, no fire, no
smoking, no leakage.
電池外觀正常、不爆炸、不起
火、不冒煙或不漏液。
2
Over-Discharge
Protection
過放保護
At20±5℃conditions,discharge
battery to 5.6V with 0.2C constant
current, then discharge with 30Ω
loading for 24 hours. Check the
appearance of battery.
在環境溫度(20±5)℃，以 0.2C 恒
流放電至 5.6V，再外接 30Ω 負載放電
24h，然後檢查電池外觀。
The appearance is normal, no
explosion, no fire, no
smoking, no leakage.
電池外觀正常、不爆炸、不起
火、不冒煙或不漏液。
3
Short-Circuit
Protection
短路保護
After fast-charging, use a
cable of 0.1Ω resistance to short
the battery for 1 hour. Then check
the appearance of battery. Cut
circuit of resistance; test the
battery’s voltage after charging
with 1C constant current for 5
seconds.
電池快速充電結束後，將正負極用
0.1Ω 電阻短路 1h 後,檢查電池外觀。
將正負極連接電阻斷開，電池以 1C 恒
流充電 5S 後，用電壓表測量電池開路
電壓。
The appearance is normal, no
explosion, no fire, no
smoking, no leakage.
電池外觀正常、不爆炸、不
起火、不冒煙或不漏液。