SDS

湖南炬神电子有限公司
HU NAN GIANTSUN POWER ELECTRONICS CO., LTD
Page6
2.3 Safety Performance
安全性能
表二
No.
序号
Items
项目
Test Method and Condition
测试方法与条件
Criteria
标准
1
Over-Charge
Protection
过充保护
At 20±5℃ conditions, after
fast-charging, use an external 10V
power to load the battery and last
for 8 hours, then check the
appearance of battery.
在环境温度(20±5)℃下, 电池快
速充电结束后,用电压为 10V 外接电源
持续给电池载入 8 小时，再检查电池外
观。
The appearance is normal, no
explosion, no fire, no
smoking, no leakage.
电池外观正常、不爆炸、不起
火、不冒烟或不漏液。
2
Over-Discharge
Protection
过放保护
At20±5℃conditions,discharge
battery to 5.8V with 0.2C constant
current, then discharge with 30Ω
loading for 24 hours. Check the
appearance of battery.
在环境温度(20±5)℃，以 0.2C 恒
流放电至 5.8V，再外接 30Ω 负载放电
24h，然后检查电池外观。
The appearance is normal, no
explosion, no fire, no
smoking, no leakage.
电池外观正常、不爆炸、不起
火、不冒烟或不漏液。
3
Short-Circuit
Protection
短路保护
After fast-charging, use a
cable of 0.1Ω resistance to short
the battery for 1 hour. Then check
the appearance of battery. Cut
circuit of resistance; test the
battery’s voltage after charging
with 1C constant current for 5
seconds.
电池快速充电结束后，将正负极用
0.1Ω 电阻短路 1h 后,检查电池外观。
将正负极连接电阻断开，电池以 1C 恒
流充电 5S 后，用电压表测量电池开路
电压。
The appearance is normal, no
explosion, no fire, no
smoking, no leakage.
电池外观正常、不爆炸、不
起火、不冒烟或不漏液。