SDS

湖南炬神电子有限公司
HU NAN GIANTSUN POWER ELECTRONICS CO., LTD
Page12
4.3 Battery Cell Performance Criteria
电芯性能检查及测试
4.3.1 Electrical characteristics
电气性能
表四
No.
序号
Items
项目
Test Method and Condition
测试方法与条件
Criteria
标准
1
Standard
Charge
标准充电
Charging the cell initially with constant current at
0.2C and then with constant voltage at 4.2V till
charge current declines ≤ 0.02C.
先用 0.2C 恒流充电至 4.2V ，再恒压 4.2V 充
电直至充电电流≤ 0.02C。
N.A.
2
Initial
Capacity
初始容量
The capacity means the discharge capacity of the
cell, which is measured with discharge current of
0.2C with3.00V cut-off voltage after the standard
charge.
该容量是指标准充电后，0.2C 放电至 3.00V 截
止电压所放出的容量。
2≧ 500mAh
3
Cycle Life
循环寿命
Test condition：
Charge: 0.5C to 4.2V
Discharge: 0.5C to 3.00V
80% or more of 1
st
cycle capacity at 0.5C
discharge of Operation
测试条件：
充电：0.5C 充电到 4.2V
放电：0.5C 放电到 3.00V
当放电容量降至初始容量的 80%时，所完成的
循环次数定义为该电芯的循环寿命
300cycles:
≥ 80%
4
Self-discharge
自放电
After the standard charging, storied the cells under
the condition as No.4.3.4 for 30days, then
measured the capacity with 0.2C till 3.00V
标准充电后， 在 No.4.3.4 条件下贮存 30 天，
再以 0.2C 放电至 3.00V 所放出的容量。
Residual capacity
> 90%
剩余容量 > 90%
5
Initial
Impedance
初始内阻
Internal resistance measured at AC 1KHz after
50% charge
半充状态下，测量其 AC 1KHz 下的交流阻抗
≤60mΩ
(Cell only)
(单电芯)
6
Cell Voltage
电芯电压
As Shipping Status
运输状态
3.6V～4.0V