operating manual

8
In order to be able to the multifunctional compressor when you are out and about, you can transport it in the storage case. The storage
case can be attached to the bicycle frame with the mounting brackets (gures 3 – 6).
The LED light (position 7 in the overview) can be turned on by pressing the button (position 4 in the overview). By pressing the button
again, you can turn the LED light o again.
Store the compressor in a dry, frost-free place. If the compressor remains unused for long periods of time, charge the battery every
3 months.
Switch the multifunctional compressor o before cleaning. Clean the housing with a soft, dry cloth. Do not use any abrasive or sol-
vent-based cleaning agents. Never allow liquids to ingress into the housing.
Only leave the compressor operating uninterrupted for a maximum for 5 minutes.
Allow the compressor to cool down for at least 15 minutes afterwards before using it again.
6.4 Storage case
6.5 LED light
Figure 3:Top tube, on top Figure 4:Top tube, underneath Figure 5:Slanting tube Figure 6:Saddle tube
7. Maintenance and care
7.1 Maintenance
7.2 Care
8. Notes regarding environmental protection
9. Contact information
Do not dispose of electrical devices with the household waste! Electronic and electrical devices must be collected sepa-
rately and sent for environmentally friendly recycling. Please contact your community or city administration regarding
disposal options for electrical and electronic scrap.
You are legally obliged to return batteries and battery packs. After use, they may be returned to us, handed in to a com-
munal collection point, or to a local dealer.
Filling process
To start the lling process press the compressor’s ON/OFF button (position 5 in the overview).
The compressor will start, during the lling process the pressure will appear on the display.
When the set target pressure has been reached the compressor will switch itself o. Press the ON/OFF button once more.
Switching o:
Press the button for selecting the unit (position 2 in the overview) for 3 seconds, the device will switch o. If no switch is pressed, the
device will switch o automatically.
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
[phone]
[phone] – 160
[e-mail]
www.eal-vertrieb.com