operating manual

7
14. Air hose
15. Adapter for bicycle valves
16. Adapter for balls
17. Universal adapter for leisure
items
18. Storage case
19. Plug-in charger
20. Charging indicator light
21. Charging cable
Figure 2:Overview of accessories
Insert the charging cable (position 21 in the overview) of the plug-in charger (position 19 in the overview) into the charging port
of the compressor (position 11 in the overview). Plug the charger into a mains socket. The charging indicator light (position 12 in
the overview) will now light up. During the charging process the charging indicator light on the plug-in charger (position 20 in the
overview) will be red. When the compressor’s battery is fully charged, the indicator light will be green. It takes approximately 4 hours
to charge an empty battery.
After charging, rst pull the plug-in charger out of the mains socket and separate the compressor from the charging cable. Always
maintain this sequence.
6.2 Charging the power pack
Setting the target pressure
Press the button for selecting the unit (position 2 in the overview). This will activate the display light. You can set the pressure unit by
continuing to press the button:
PSI -> BAR -> KGF/CM²
With the (-) and (+) buttons (position 3 and 6 in the overview) you can set the target pressure. After you have set the pressure, press
the unit selection button once more, and the display will now show 0.00 again in the chosen unit.
Connecting the air hose
Screw the end of the air hose with the external thread (position 14 in the overview) into the compressor’s connector (position 8 in
the overview).
Using the adapter
If you would like to ll a tyre with an auto valve (Schrader valve), you will not require an adapter. Screw the end of the air hose with
the internal thread onto the valve. Now you can switch on the compressor and ll the bicycle tyre.
Bicycle valve adapter (for Dunlop and Sclaverand valves) (15):
For Sclaverand valves: Undo the knurled screw of the valve piston and push down briey once.
Screw the valve adapter, using the knurled crown, down onto the bicycle valve.
Screw the end of the air hose with the internal thread onto the adapter. Now you can switch on the compressor and ll the bicycle tyre.
After you have nished lling the tyre, detach the air hose and the adapter from the valve.
For Sclaverand valves: Tighten the knurled screw of the valve piston up again.
Adapter for balls (16):
Screw the adapter for balls into the internal thread of the air hose. Insert the adapter into the valve of the ball. Now you can switch
on the compressor and ll the ball.
Universal adapter for leisure items (17):
Screw the universal adapter into the internal thread of the air hose. Insert the universal adapter into the lling connection of your
leisure equipment. Depending on version, it is possible that the universal adapter will need to be held rmly during the lling process.
Now you can switch on the compressor and start the lling process.
6.3 Operating the compressor
Checking the charge status
Press the button for selecting the unit (position 2 in the overview). This will activate the display light. The battery symbol
indicates the charge status (empty, 25%, 50%, 75%, 100%).
