User manual

4
Part no. 16408
Bicycle wall bracket
Assembly instructions
- Connect both wheel rails (item 8) with the vertical rail (item 5)
- Fasten the rails in the front and rear drill holes using the M 5 x 8 bolts (item 11) and the
M 5 nuts (item 12)
- Wall attachment with M 5 x 12 countersunk bolts (item 10) and M 5 nuts (item 12)
- When attaching the wall bracket, make sure the wheel rails are fastened level
Caution:
Watch out for hidden cable lines while drilling. Do not damage or drill into structural parts.
- Insert the dowel (item 7) into the drill holes (4 x 30 Phillips cross head screw (item 6)
- Put the adjustment slide (item 2) into the vertical rail from the top
- The elongated hole for the safety bolts (item 4) must be located on the right-hand side
- The safety bolts must lead through both of the vertical rail plate-cheeks
- Push the safety bolt down – the adjustment slides are secured
- Guide the bicycle frame bracket (item 1) into the adjustment slides
- Secure the frame with the retaining pin (item 3)
- Turn the frame bracket right side up
- Put on the bicycle – the pedal toward the wall must face upwards
- Lay the bicycle frame bracket over the frame – the bicycle is secured
Parts list:
Item 1 Bicycle frame bracket 1x
Item 2 Adjustment slides 1x
Item 3 3 Ø mm retaining pin 1x
Item 4 Safety bolts 1x
Item 5 Bicycle rails 1x
Item 6 Phillips cross head screw 4 x 30 6x
Item 7 Dowel 6x
Item 8 Wheel rails 2x
Item 9 Countersunk bolts M 5 x 12 2x
Item 10 Screws M 5 x 8 4x
Item 11 Nuts M 5 6x
Hex hey
Thank you for having decided in favour of a Eufab product!