Operation Manual

461307064 (RS-000)

3. ISTRUZIONI PER L’UTENTE

INSTRUCTIONS FOR THE USER

OVEN SIDEWALL GRIDS (ﬁ g. 10)

To allow for a better cleaning of the side grids, you can extract

them this way:

• Push with a ﬁ nger on the last of the slots to release the grid

from its hold (A).

• Lift it towards the top and extract the grid.

To put them back into place, reverse the order of this

operation.

SELF-CLEANING PANELS - only certain versions

Oven walls are protected by panels coated with a grease-proof,

microporous enamel that absorbs and eliminates splattering

during baking.

If there is a lot of liquid or grease, dry immediately with a

damp sponge and heat the oven for 2 hours on the maximum

thermostat position. Wait for the oven to cool down and then go

over it again with a damp sponge. If you are unable to remove

all the substances, repeat the above procedure.

It is, however, advisable to periodically remove the panels and

wash them with warm soapy water and dry them with a soft

cloth.

To remove them follow these instructions:

• Extract the side grids as indicated in the previous

paragraph.

• Remove both side panels (PL) (ﬁ g. 11).

• Remove back panel by unscrewing respective locking

screws (V) (ﬁ g. 12).

• Repeat previous operations in reverse order to replace all

elements.

IMPORTANT!! Position both side panels (PL) by taking the locking

pin (A) out of the hole (B) (ﬁ g. 11).

REPLACING THE OVEN LAMP (ﬁ g. 13)

Attention!! Ensure the appliance is switched off before

replacing the lamp to avoid the risk of electric shock.

If the oven lamp needs replacing the new lamp must have the

following characteristics:

15 W - 230 Vac - 50 Hz - E 14 - resistant to high temperatures

(300°C).

To substitute the bulbs follow these instructions:

• Extract the side grids as indicated in the previous

paragraph.

• Unscrew glass protection cap (V) from bulb holder by lifting

it with a screwdriver (C) against the inside wall of the oven.

• Substitute the bulb and reposition all elements back by

following the operation in reverse order.