Operation Manual

461307064 (RS-000)
22
P
1
2
20
S
Q
A
T
19
GB INSTRUCTION FOR THE INSTALLER
MAINTENANCE
Before replacing any spare parts it is vital to
disconnect the appliance from the electricity
mains.
REPLACING ELECTRICAL COMPONENTS
• To replace the oven lamp please refer to instructions
on page 18.
• To access other electrical components the oven
will have to be removed from its housing unit (see
«INSTALLING AND FIXING THE OVEN» section).
Oven extraction allows access to the terminal board
(T)(fi g. 19).
• If the power cable needs replacing always keep
the earth wire longer than the phase wires
and do follow all instructions given in the
“ELECTRICAL CONNECTION” section.
• Remove the rear protection panel (Q) to have
access to the gear motor, heating elements and
temperature limiting device (fi g. 19).
• To change lamp holder (P), remove the superior
protection (A) and the side panel, then use a
screwdriver to push the two locking tabs (fi g. 20)
and remove the lamp holder from the inside of the
oven.
• To replace the thermostat, the commutator, the
programmer and the indicator lights, remove
protection box (S) (fi g. 19). Remove the knobs and
undo the screws underneath to free the components
that need replacing.