Operation Manual

461307064 (RS-000)
20
V
V
15
GB
INSTRUCTION FOR THE INSTALLER
INSTALLING AND FIXING THE OVEN
The oven can be housed into a cabinet or into a
base module, making room for its volumes as
shown in figure 14.
To guarantee proper aeration of the appliance,
remove the rear panel of the base module unit
or make an escape opening (A), as shown in
figure 14.
At this point, carry out the following operations
• After installing the electric hob, partially insert the
oven.
• Proceed connecting the hob and the oven.
• Fix the oven unit with the supplied screws (V)
(fig. 15).
The oven must be supported by a base that will
withstand its full weight. Screws are only used to
locate the appliance inside its cabinet housing.
COOKING APPLIANCES MATCHING SCHEME
HOBS OVENS
P58...... FM 60-3-CC
TECHNICAL INFORMATION
All instructions related to installation and
maintenance operations listed in this section
must be carried out only by authorised
personnel.
The manufacturer cannot be held responsible
for any damage to persons or property resulting
from an incorrect installation of the appliance.
UNPACKING YOUR APPLIANCE
• Once the packaging has been removed, thoroughly
check that the appliance is in perfect condition. If
you have any doubts do not use the appliance and
call our Service Centre.
• Do not move the appliance by the handles.
• Some parts mounted on the appliance are protected
by a plastic fi lm. This protection must be removed
before using the appliance. We recommend slitting
the plastic fi lm along the edges with a sharp knife
or pin.
All packaging materials used (cardboard boxes,
bags, polystyrene foam, nails, etc.) must be
kept out of the reach of children, as they are a
potential hazard source. All packaging materials
used are environmentally-friendly and recyclable
(wooden bits are free from chemicals, cardboard
is 80-100% recycled, protective bags are made
in polyethylene (PE), bands in polypropylene
(PP) and padding in polystyrene foam (PS)
without chloro-fl uoro-carbides. Waste materials
can undergo treatment and be recycled saving
on new raw materials and on the amount wasted
volumes. For this purpose we suggest you take
the packaging material back to the shop you
bought the appliance or to a collecting service.
Ask your local service for the nearest service.
WARNINGS
• As this is a built-in oven, please ascertain that
the walls or panels surrounding the appliance
can withstand a temperature of over 70 K.
• Also make sure that the glue that joins the
laminated plastic coat to the unit can withstand
a temperature of around 150°C, to avoid the
laminated coat to unglue.