Operation Manual

461307055 (A-000)

SET TIME

The oven is equipped with a digital clock indicating hours and minutes. After connecting the oven to the mains,

and with the programme selector knob (A) in STOP position, set the current time as follows:

• Press and hold the button for per a few seconds until a beep is heard.

The hour value starts ﬂ ashing when the button is released.

• Set the hour value with the and/or buttons.

• Press the button again. The minutes value starts ﬂ ashing when the button

is released.

• Adjust the minutes value with the and/or buttons.

• Press the button again to conﬁ rm. The display now shows the set hour

and minute values with a ﬂ ashing cursor to indicate that the operation has been

completed successfully.

Note: The above procedure must be started within 5 seconds, after which the values stop ﬂ ashing and the

oven exits SET TIME mode.

SET TIMER

The timer can be set in all modes, except during programmed cooking, as the values used for the timer are the same

as the COOKING TIME setting.

• Press the button. The relative symbol and the “0” value for the

minutes start ﬂ ashing.

• Set the minutes with the and/or buttons (max 199).

• Press again to conﬁ rm. The display now shows only the symbol

and a countdown timer starts from the set minute value. Once the set time has

elapsed, a beeper sounds for 1 minute. Press any button to mute the beeper.

Note: The TIMER may be deactivated ahead of time by pressing .

CONTRAST SETTING

Set the display contrast for the correct viewing angle, which depends on the height of the oven from the ﬂ oor

and the stature of the user:

• Press then to move the viewing angle upwards.

• Press then for optimised vision from the front.

INSTRUCTIONS FOR THE USER