Operation Manual
461307055 (A-000)
6
1
2
3
4
5
6
1a
2
3
4
1
3
4
5
6
1b
GB
INTRODUCTION
The multifunction electric oven allows both natural convection
and fan assisted cooking, to let you choose the most suitable
heating method for the dishes prepared. The oven may be
equipped with guide bars, either fi xed (fi g. 1a) or telescopic
(fi g. 1b), for the following accessories:
• oven grille (fi g. 2)
• drip tray – h 34 mm (fi g. 3)
• baking or pizza tray – h 20 mm (fi g. 4)
• spit holder + spit + forks + handle
• cooking temperature probe
Note: The type and the quantity of accessories may vary
according to the model or the market.
The main safety features of the oven are described as follows
for optimum, safe usage:
1. Temperature limiter or safety thermostat. This device
is activated in the event of main thermostat malfunction.
When activated, the power supply to the oven is temporarily
switched off to prevent overheating. Never try to rectify a
problem yourself. Switch off the oven and contact your
local authorised service centre.
2. Cooling or tangential fan. This cools the control panel, the
knobs, the oven door handle and the electrical components.
It is activated automatically whenever the oven is used,
to prevent overheating and to speed up cooling times. It
continues running for approximately 7-8 minutes after turning
the oven off.
3. OVEN AIR TEMPERATURE PROBE safety system
• If the probe is short circuited, an alarm sounds and the
fl ashing message “E” is shown on the oven air temperature
display as soon as a programme is started.
• If the probe circuit is open, the system checks that the oven
temperature has reached at least 60°C after 8 minutes of
operation. If this is not the case, the oven is switched to
alarm mode. This safety system also functions even if the
oven door is open during use. This safety function is disabled
for function 1 (room temp. air defrost).
4. COOKING TEMPERATURE PROBE safety system (if fi tted)
• If the probe is short circuited, an alarm sounds and the
fl ashing message “E” is shown on the oven temperature
display a few seconds after a programme is started (max. 5
seconds).
• If the probe circuit is open, it will not be detected by the
software, therefore, even if fi tted, the above symbol will not
be displayed.
• With the probe fi tted and the selector set to one of the grill
programmes (8, 9 or 10), an alarm sounds and all electrical
utilities (except the light) are switched off.
INSTRUCTIONS FOR THE USER