Installation Instructions
C
o
p
y
r
i
g
h
t
©
2021,
E
u
C
o
n
t
r
o
l
s
C
o
r
p.
All rights
r
e
s
e
r
ved.
Specifications subject to change without n
o
t
i
c
e
.
All
product names, trademarks, and registered trademarks are property of
their
r
e
sp
e
c
t
i
v
e
o
wn
e
r
s.
W
902
-
DXXY
MKTG
20221018
PROPRIETARY
&
C
ONFIDENTIAL
FCCID:
Bluetooth 2AJ2N-W902-DBT: Channel 0 to 39
Zigbee 2AJ2N-W902-DZB: Channel 11 to 25
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
To maintain compliance with FCC's RF exposure guidelines, the distance must be at least 20cm between the
radiator and your body, and fully supported by the operating and installation configurations of the transmitter and
its antenna(s).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.