Specifications

BluetoothmeshPIR,Photo&LightingControl
ON/OFF&0‐10VDimming
Specifications subject to change without notice
EuControlContact:[e-mail]lLosAngeles,CA90248l8885359580
© EuControls, Inc.
◙ Los Angeles, California ◙ T: 888 535-9580 ◙ E: [e-mail] ◙ www.EuControls.com ◙ Rev B - 10/10/2022
U.S. Patent Pending
4
BluetoothWireless
S830‐PL‐DBT
PIR+Light+Photo+Temp
Standard Lens Coverage
FCC ID 2AJ2N-S830-PL-DBT: Channel 0 to 39
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC's RF exposure guidelines, the distance must be at least 20cm between the radiator
and your body, and fully supported by the operating and installation configurations of the transmitter and its antenna(s).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.