Owner manual

Manual EKS ActiveX
®
Module Ethernet TCP/IP
3.5.4 LastState (ReadOnly)
 Description Status of the last method called (0=OK or status number)
 Syntax long = object.LastState;
 Comments After a method is run (Read, Write, …) or after an event (OnKey, OnRead, ...), you can
determine here whether the method was run correctly. Status numbers in the range
from 0 to 127 (0
hex
to 7F
hex
) are generated by the EKS and are documented in the
manual for the EKS Electronic-Key adapter. Status numbers between 128 and 255
(80
hex
to FF
hex
) are generated by the ActiveX
®
module.
 Data type long
 List of status numbers for the ActiveX
®
module:
Attention!
Immediately after a method has been called or an event has been triggered you should poll the value
in the property LastState. Otherwise the property LastState could be overwritten by another method,
as only the status message from the last method run is given in the property LastState. This warning
also applies to internal methods that run in the background and that are not started by you.
Value Description
hex dec
0x90 144
WrongParam
The TCP port given in the property Port is not is the range >1024 und <65535
0xA0 160
DeviceNotOpened
The connection to the EKS has not been opened, please run the method Open.
0xB0 176
ReadTimeOut
It was not possible to correctly complete the method Read, the method has timed out.
0xB1 177
WriteTimeOut
It was not possible to correctly complete the method Write, the method has timed out.
0xB2 178
TimeOut
An internal method in the ActiveX
®
module has timed out.
0xC0 192
NothingToRead
The number of bytes of data to be read, as defined by the property CountData, is 0.
0xC1 193
NothingToWrite
The number of bytes of data to be written, as defined by the property CountData, is 0.
0xE0 224
OpenFailed
The method Open failed.
0xE1 225
OpenActive
The method Open is still active.
0xE8 232
Suspend
The computer will be placed in the suspend mode.
0xE9 233
ResumeSuspend
The suspend mode has been terminated.
0xEA 234
ConnectionTimeOut
Connection timeout to the EKS. It was not possible to establish a connection to the EKS in the time specified.
0xEB 235
ConnectionLost
The connection to the EKS has been interrupted.
0xEC 236
Reconnect
The connection to the EKS has been re-established.
0xFF 255
Busy
The ActiveX
®
module is busy processing a method, the request cannot be run.
102030-02-10/12 Subject to technical modifications Page 11/20