System Manual
Table Of Contents
- 1 General notes
- 2 Safety precautions
- 3 Function
- 4 Technical data
- 5 Mounting
- 6 Electrical connection
- 7 Setup
- 8 Data transfer via the Ethernet TCP/IP interface
- 9 Exclusion of liability
- 10 Service and repair
- 11 Guarantee
Manual EKS Electronic-Key Adapter Ethernet TCP/IP
2100420-03-05/19 Subject to technical modifications Page 25/34
2. Click Configuration.
The Configuration screen for the EKS web interface is now displayed.
1. Enter the desired IP address and the subnet mask. If the network has a gateway, also enter this information.
2. Click the Send button.
The following message is displayed: The settings were saved, to apply settings please switch power
off/on…
3. Interrupt the power supply and connect the Electronic-Key adapter again in order to activate the settings.