Specification
7 of 15
Eucatex Eucafiber, Eucaplac, Eucatile, Eucaboard, Hardboard, MDF, HDF
Safety Data Sheet
According To Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules And Regulations And According To The Hazardous Products Regulation (February 11, 2015).
8.2. Exposure Controls
Appropriate Engineering Controls: The following applies to the product if it is cut, sanded or altered in such a way that excessive
and/or significant particulates and/or dusts may be generated: Emergency eye wash fountains and safety showers should be
available in the immediate vicinity of any potential exposure. Ensure adequate ventilation, especially in confined areas. Proper
grounding procedures to avoid static electricity should be followed. Use explosion‐proof equipment. Use local exhaust or general
dilution ventilation or other suppression methods to maintain dust levels below exposure limits. Power equipment should be
equipped with proper dust collection devices. It is recommended that all dust control equipment such as local exhaust ventilation
and material transport systems involved in handling of this product contain explosion relief vents or an explosion suppression
system or an oxygen‐deficient environment. Ensure all national/local regulations are observed.
Personal Protective Equipment: Gloves. Protective clothing. Protective goggles. Insufficient ventilation: wear respiratory protection.
Materials for Protective Clothing: Chemically resistant materials and fabrics.
Hand Protection: Wear protective gloves.
Eye and Face Protection: Chemical safety goggles.
Skin and Body Protection: Wear suitable protective clothing.
Respiratory Protection: If exposure limits are exceeded or irritation is experienced, approved respiratory protection should be worn.
In case of inadequate ventilation, oxygen deficient atmosphere, or where exposure levels are not known wear approved respiratory
protection.
Other Information: When using, do not eat, drink or smoke.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
9.1. Information on Basic Physical and Chemical Properties
Physical State
Appearance
Odor
Odor Threshold
pH
Evaporation Rate
Melting Point
Freezing Point
Boiling Point
Flash Point
Auto‐ignition Temperature
Decomposition Temperature
Flammability (solid, gas)
: Solid
: MDF panel; Straw yellow (light brown)
: No distinctive odor
: Not available
: Not available
: Not available
: Not available
: Not available
: Not available
: Not available
: 425 ‐ 475 °F (218.33 ‐ 246.11 °C)
: Not available
: Notavailable
05/17/2019 EN (English US) 7/15