Instructions / Assembly

ManualsBrandsEUCATILE ManualsKitchen32 sq. ft. 3/16 in. x 48 in. x 96 in. Beadboard White True Bead Panel

Table Of Contents

BEFORE YOU BEGIN, PLEASE READ

Be sure to read and follow the instructions.

Eucaboard / Eucaplac/ Eucatile paneling is intended for dry interior use only

and requires care in handling.

Eucatex paneling should not be used in environments where an accumulation

of water, grease, smoke, or other surface contaminants will require frequent

cleaning to remove accumulations.

Panels cannot be installed directly to studs in mobile homes.

When using cleaning materials, experiment with scrap paneling or spot clean

in an inconspicuous area. Eucatex is not responsible for any damage caused by

non-recommended cleaning methods.

Always check your building code. Panels are Class III fire rated and most panels

are only allowed to be installed over a solid wall under most building codes.

Material Safety Data Sheet (MSDS) containing potential physical and health

hazard information is available at your retailer.

Care should be taken during installation to allow for space between panels

and heat producing appliances and ignition sources. Consult your local building

code authority for guidelines and requirements.

Improper use and/or installation will void any warranty of the product.

CONDITIONING PANELS

Condition panels by placing them in the room to be paneled at least 72

hours prior to installation.

Stack the panels or lean them against a wall, with spacers between each sheet.

This allows the room air to circulate around each panel for proper acclimation.

24 hours

48 hours

WALL PREPARATION

Installing paneling over existing true

walls requires no preliminary

preparation. Sanding high spots on

the wall is generally about all you

have to do.

Exterior Wall

Vapor Barrier

Gypsum

Panel

Panels of 1/8” thickness must

be applied to solid walls only, and

above the grade.

Panels of 3/16” thickness or

greater may be installed directly to

the stud frame, above or below

grade.

To install Panels directly to studs, it

is necessary to have a solid

insulated exterior wall and 4-mil

or greater polyethylene vapor

barrier behind the studs.