Installation Guide

Eucatex of North America
2500 Northwinds Parkway, Suite 685
Alpharetta, Georgia 30004
(678)-624-0160
Fax [phone]
www.eucatex.com.br
Caulk
Allow adhesive to cure for 24 hours before applying caulk. Use only 100% silicone sealant (not siliconized acrylics) to
thoroughly caulk all seams, edges around panels, around and behind all fixtures and in between seams.
Clean up
For solvent based adhesive, clean up surface with mineral spirits- dampened rag (do not use lacquer thinner). For low
VOC adhesive , wipe off all excess adhesive on the surface with water dampened rag.
Panels may be cleaned when needed with mild soap and water dampened rag. Do not use abrasive cleaners on your new
wall panels.
Tools and Supplies for Installation
Assemble all your tools and supplies before you begin the job. Here is what you will need for most common wall
paneling installations:
- Tape measure
- Level
- Pencil compass
- Hammer and nail set
- Padded wooden block (or rubber mallet)
- Power or handsaw (with short fine-toothed blade)
- Carpenter’s square
- Chalk line
- Drill
- Adhesive caulking gun
- Eye goggles (must be worn when using any power or hand tools)
- Keyhole saw/miter box
- Tub caulk
- Cloths for clean-up