User's Manual
Table Of Contents
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Installing the SIM Card, Battery, and PC Tracker Tool
- Chapter 3 Using Your Tracker GT100
- Chapter 4 Using the PC Tracker Tool
- 4.1 Starting the PC Tracker Tool
- 4.2 Changing the Contact List Settings
- 4.3 Configuring the SMS Display Settings
- 4.4 Setting the Help Options
- 4.5 Configuring the Park Settings
- 4.6 Configuring the Surveillance/Remote Monitoring Settings
- 4.7 Configuring the Power Rule Settings
- 4.8 Changing the Direct Dial Settings
- 4.9 Configuring the Speed Alert Settings
- 4.10 Configuring the Tracking Log Settings
- 4.11 Changing the Password
- Chapter 5 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Tracker GT100 Functions and LED Status
- Appendix C Short Messages (SMS) Format for GPS Data
Tracker GT100 User Guide Proprietary to EU3C Company Limited Reserved B-1
AppendixBTrackerGT100FunctionsandLEDStatus
B.1 Functions
Function Setting Description
SOS/911
Press and hold the red SOS button for
three seconds
Automatically dial preset emergency number (911)
Surveillance
Enable the surveillance function in the
Tracker Tool program. The caller’s
phone number must be
pre-programmed in the "Allow calls"
list. The caller dials in and waits for
over 8 seconds.
Caller uses the device as a surveillance voice monitor
Tracking log
Enable the Tracking function in the
Tracker Tool program and sets the
recording interval.
The Tracker GT100 will record its GPS position at
pre-programmed intervals and store the location on a flash
card for downloading or connecting to Google Earth from a
PC.
Park
Press and hold the red Park button to
enter parking mode and leave the
device in the vehicle.
Once the Tracker GT100 detects motion or travels outside
a pre-programmed boundary, the Tracker GT100 will trigger
a "Moving" SMS message with its current location.
Help
Press and hold the Help button for
three seconds.
The Tracker GT100 will send out a Help message to
pre-programmed numbers in the contact list.
Speed dialing
Set phone numbers for each
corresponding (#1, #2, #3) buttons
Press the speed dial button to make calls to the
pre-programmed number.
Battery low
Set the device to notify the user when
battery reaches a low level using the
Tracker Tool.
The Tracker GT100 will automatically send out a battery
low SMS message to the pre-programmed number.
Speed alert
Set device to notify the user when the
device is traveling at a speed higher
than the preset value.
The Tracker GT100 can be programmed to send out an
SMS message when the device is traveling over the preset
limit.