User's Manual
Table Of Contents
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Installing the SIM Card, Battery, and PC Tracker Tool
- Chapter 3 Using Your Tracker GT100
- Chapter 4 Using the PC Tracker Tool
- 4.1 Starting the PC Tracker Tool
- 4.2 Changing the Contact List Settings
- 4.3 Configuring the SMS Display Settings
- 4.4 Setting the Help Options
- 4.5 Configuring the Park Settings
- 4.6 Configuring the Surveillance/Remote Monitoring Settings
- 4.7 Configuring the Power Rule Settings
- 4.8 Changing the Direct Dial Settings
- 4.9 Configuring the Speed Alert Settings
- 4.10 Configuring the Tracking Log Settings
- 4.11 Changing the Password
- Chapter 5 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Tracker GT100 Functions and LED Status
- Appendix C Short Messages (SMS) Format for GPS Data
Powering Up the Tracker GT100
Tracker GT100 User Guide Proprietary to EU3C Company Limited Reserved 3-3
3.3 PoweringUptheTrackerGT100
1. Press the Power ON/OFF button and hold for over four seconds.
2. The Tracker GT100 will power ON and enter Standby mode as it acquires a satellite signal. Longer satellite
searching time may occur when powering up the Tracker GT100 for the first time or if the Tracker GT100 has been
moved to another state or country since the last time it was used.
3. If there is no satellite signal or movement detected for a long period of time, the Tracker GT100 will enter power
saving mode as defined by the power saving parameter set using the PC Tracker Tool.