Specifications

ETSI
Final draft ETSI EN 300 328 V1.8.1 (2012
-
04)
82
o) Describe the test modes available which can facilitate testing:
......................................................................................................................................................
......................................................................................................................................................
......................................................................................................................................................
p) The equipment type (e.g. Bluetooth
®
, IEEE 802.11™ [i.3], proprietary, etc.):
......................................................................................................................................................
E.2 Combination for testing (see clause 5.1.3.3 of
EN 300 328 V1.8.1)
From all combinations of conducted power settings and intended antenna assembly(ies) specified in clause 3.1 m),
specify the combination resulting in the highest e.i.r.p. for the radio equipment.
Unless otherwise specified in EN 300 328, this power setting is to be used for testing against the requirements of
EN 300 328. In case there is more than one such conducted power setting resulting in the same (highest) e.i.r.p. level,
the highest power setting is to be used for testing. See also EN 300 328, clause 5.1.3.3.
Highest overall e.i.r.p. value: ......... dBm
Corresponding Antenna assembly gain: ......... dBi Antenna Assembly #: .........
Corresponding conducted power setting:
(also the power level to be used for testing)
......... dBm Listed as Power Setting #: .........
E.3 Additional information provided by the applicant
E.3.1 Modulation:
ITU Class(es) of emission: .................
Can the transmitter operate unmodulated?
yes no
E.3.2 Duty Cycle
The transmitter is intended for: Continuous duty
Intermittent duty
Continuous operation possible for testing purposes