Specifications

ETSI
Final draft ETSI EN 300 328 V1.8.1 (2012
-
04)
79
• Receiver spurious emissions
.........................................................................................
g) The different transmit operating modes (tick all that apply):
Operating mode 1: Single Antenna Equipment
Equipment with only 1 antenna
Equipment with 2 diversity antennas but only 1 antenna active at any moment in time
Smart Antenna Systems with 2 or more antennas, but operating in a (legacy) mode where only 1
antenna is used. (e.g. IEEE 802.11™ [i.3] legacy mode in smart antenna systems)
Operating mode 2: Smart Antenna Systems - Multiple Antennas without beam forming
Single spatial stream / Standard throughput / (e.g. IEEE 802.11™ [i.3] legacy mode)
High Throughput (> 1 spatial stream) using Occupied Channel Bandwidth 1
High Throughput (> 1 spatial stream) using Occupied Channel Bandwidth 2
NOTE: Add more lines if more channel bandwidths are supported.
Operating mode 3: Smart Antenna Systems - Multiple Antennas with beam forming
Single spatial stream / Standard throughput (e.g. IEEE 802.11™ [i.3] legacy mode)
High Throughput (> 1 spatial stream) using Occupied Channel Bandwidth 1
High Throughput (> 1 spatial stream) using Occupied Channel Bandwidth 2
NOTE: Add more lines if more channel bandwidths are supported.
h) In case of Smart Antenna Systems:
• The number of Receive chains: ...........
• The number of Transmit chains: ...........
symmetrical power distribution
asymmetrical power distribution
In case of beam forming, the maximum beam forming gain: ...........
NOTE: Beam forming gain does not include the basic gain of a single antenna.
i) Operating Frequency Range(s) of the equipment:
• Operating Frequency Range 1: ........... MHz to ........... MHz
• Operating Frequency Range 2: ........... MHz to ........... MHz
NOTE: Add more lines if more Frequency Ranges are supported.
j) Occupied Channel Bandwidth(s):
• Occupied Channel Bandwidth 1: ........... MHz
• Occupied Channel Bandwidth 2: ........... MHz
NOTE: Add more lines if more channel bandwidths are supported.
k) Type of Equipment (stand-alone, combined, plug-in radio device, etc.):
Stand-alone