Instruction manual

2
1.3 Cable Overview
Type A: Type B:
Power cable
RJ45 network cabl
e
RESET
GND
Alarm-out
Alarm-in
GND
Power cable
RJ45 network cabl
e
RESET
GND
Alarm-out
Alarm-in
GND
Cable Description
Power cable
Connect to DC12V power supply.
Note: The power adapter is optional.
RJ45 network cable
Connect it to the supplied RJ45 cable extender adapter for cable extension, and prepare
another RJ45 network cable with suitable length for your connection.
GND
Ground wire, used for reset default or external device connection.
Alarm-in
Reserved for connecting to an external alarm device. For details, please refer the user
manual of your alarm device.
Alarm-out
Reserved for connecting to an external alarm device. For details, please refer the user
manual of your alarm device.
RESET
Remove the insulating coating of this wire, and twist it with a ground wire together to reset
default. This will reset all parameters, including the IP address to factory default settings.
Note: Disconnect power before twisting these two wires together, and connect to
power again for reset default.
1.5 External Alarm Connection
This camera supports external I/O device connection for easy connection.
Below shows you how to connect an external device to this camera.