Operation Manual
42 - Epic 442 Assembly and User Manual
4930659-02
Shock hazard.
Disconnect power before removing
any protective covers.
WARNING
Opening / Replacing Acrylics
The bench acrylic is secured in place by 2
screws at the front corners. Use a Phillips
screwdriver to remove the screws. The acryl-
ic will lift up in front. On the inside of the
bench, along the front, are two supports for
the bench acrylic. Swing them up to hold
the bench acrylic open.
To remove the bench acrylic, simply pull it
out of the channel at the back.
The canopy acrylic is secured by 5 screws
along the front edge of the canopy. Use a
Phillips screwdriver to unscrew all 5 screws
and the aluminum channel will swing down
to release the acrylic. The screws will remain
captive in the channel. Swing the channel
open fully and the front edge of the canopy
acrylic will drop down.
To remove the canopy acrylic, disconnect
the exciters and lift it out of the channel
along the back edge.
When you are nished, reverse the above
directions to secure the acrylic shields.
Acrylics vary greatly over time in their abil-
ity to effectively transmit UV light. Acrylics
sold by ETS have been life tested to ensure
proper transmission throughout their useful
life.
Replace any acrylic that appears damaged.
This includes deep scratches, many small
scratches, gouges and cracks.
Removing / Replacing Fluorescent
Lamps
After opening the acrylics, replace lamps as
follows.
1. Grasp the lamp at one end and at the
middle and turn the lamp one quarter
turn. Gently remove the lamp from its
holders. Due to the tight spacing of the
lamps, you may nd it helpful to remove
the end lamp in the bench, or the mid-
dle lamps in the canopy, and work your
way across.
2. Reinstall the lamp by inserting the pins
located on the ends of the lamp into the
slots on top of the lamp holders and turn
the lamp a quarter turn. It should click
in place.
Replacement Lamps
To be assured of maximum tanning effec-
tiveness, change lamps after approximately
800-1000 hours of use. Lamps used longer
than that begin to lose their tanning effec-
tiveness even though they continue to light.
We recommend using the lamps specied
below. Use of uncertied lamps is a viola-
tion of Federal regulations and will void
your warranty.
The following lamps have been certied for
use in your tanning bed:
ETS ELITE Ultra Model
FR71-T12-160W BP
Heraeus OH C 400 EF (facial unit)
Soft Facial LightSources Model
F25T5/BL/BP (shoulder unit, if equipped)