Operation Manual

Epic 442 Assembly and User Manual - 37
4930659-02
Scenario 7 - Non T-Max® Remote System wired
to unit
Most non-T-Max® remote systems control the
sunbed by the use of a relay. The relay operates
the sunbed by connecting and disconnecting
a pair of wires leading from the sunbed. Refer
to the user’s manual provided with your remote
system to determine if it operates in this way.
To connect your sunbed to this type of system
a remote interface kit is required. Contact your
place of purchase to obtain the kit. The illustra-
tion below details a typical connection. Follow
the instructions provided with the kit and from
the remote’s manual to make the necessary con-
nections. You will also need to enable Parameter
19. See Parameters for instructions.
Setting the sunbed address manually
Before connecting your sunbed to the T-
Max® Manager or T-Max® 3W, the address
of your sunbed must rst be set. Set the “id”
manually as described below.
1. With the bed sitting idle (display show-
ing “0”), press the STOP button and,
without releasing it, press the START/
TIME button and hold both for 3 seconds
(listen for the conrmation beep).
2. The display will change to “PRAM” for 2
seconds, then “P 1” for 2 seconds, then
show the parameter value.
3. Use the + and/or - buttons to change this
number to the desired address.
4. Press the STOP button to return to idle.
The remote connection is not designed to
supply or accept high voltage, nor can it
provide power to an external timer. The
sunbed’s remote interface circuitry operates
on 5 volts, attempting to connect it to any
higher voltages will damage the sunbed as
well as void your warranty.
CAUTION